Komatsu — INITIAL 250 HOURS MAINTENANCE (ONLY AFTER THE FIRST 250

MAINTENANCE PROCEDURE MAINTENANCE 1. Stop the engine. 2. Check that the coolant temperature has gone down enough to make it possible to touch the radiator cap sur- face by hand, then turn radiator cap (1) slowly until it con- tacts the stopper to release the pressure. 3. Following this, push radiator cap (1), turn it until it con- tacts the stopper, then remove it. 4. Remove the undercover, then set the container under drain valve (2) and drain plug (3) to catch the coolant mixture. Open drain valve (2) at the bottom of the radiator and drain the coolant. Then open drain plug (3) in the cylinder block and drain the coolant. 5.

After draining the coolant, close drain valve (2) and drain plug (3), and fill with city water. When the radiator is full, start the engine and run at low idling to raise the temper- ature to at least 90°C, then continue to run for approx. 10 minutes. 6. Stop the engine, open drain valve (2) and drain plug (3), and drain the water. 7. After draining the water, clean the radiator with detergent. For the cleaning method, follow the instruction of detergent. 8. Close drain valve (2), then wrap drain plug (3) with sealing tape and close it. 9. Install the undercover. 10. Add coolant mixed with antifreeze until it overflows from the water filler.

Decide the proportions of antifreeze and water according to the table for the mixing rate of water and anti- freeze. 11. To remove air in the cooling system, run the engine for 5 minutes at low idle, then for 5 minutes at high idle. (While doing this, leave the radiator cap removed.) 12. Drain the coolant from reserve tank (4), clean the inside of the reserve tank, then add water until the coolant level is between the FULL and LOW marks. 13. Stop the engine, wait for approx. 3 minutes, then add coolant until the coolant level is near the coolant filler port, and tighten the cap. Check the coolant level and add coolant if necessary. 4-24