Komatsu — INITIAL 250 HOURS MAINTENANCE (ONLY AFTER THE FIRST 250

MAINTENANCE MAINTENANCE PROCEDURE EVERY 100 HOURS MAINTENANCE Maintenance for every 50 hours service should be carried out at the same time. LUBRICATING NOTICE If any abnormal noise is generated from any greasing point, carry out greasing regardless of the greasing interval. Carry out greasing of greasing points 1 - 7 every 10 hours for the first 100 hours on a new machine. 1. Set the work equipment in the greasing posture below, then lower the work equipment to the ground and stop the engine. 2. Using a grease pump, pump in grease through the grease fittings shown by arrows. 3. After greasing, wipe off any old grease that was pushed out.

(1) Blade cylinder foot pin (1 point) (2) Blade cylinder rod end (1 point) (3) Blade foot pin (2 points) (4) First boom foot pin (2 points) (5) Boom cylinder foot pin (1 point) (6) First boom-Second boom coupling pin (2 points) 4-43