5-101.bk Page 38 Friday, March 17, 2006 11:05 AM 1 2 Figure 5-49 — Checking Valve Spring Tension 200304a Figure 5-48 — Checking Valve Seat Runout [213 GB] Injection Nozzle Holder Insert [213 MB] Valve Springs 1. Visually inspect inside surfaces of coils. Also, feel inside surfaces of spring for any indication of roughness or grooving. If any of these conditions exist, replace spring. The injection nozzle holder insert is machined to provide a press fit in cylinder head. INJECTION NOZZLE HOLDER INSERT REMOVAL Refer to Figure 5-49. 1. To remove injection nozzle holder insert, tap ID with 3/4-10 tap. 2. Check spring tension on universal spring tester J 22738-02. Refer to Figure 5-50. 2.
Install nozzle sleeve puller J 29880 (2) to slide hammer J 2619-01 (1) or equivalent. Part No. 575GC213 (E7) 142.5–157.5 lb. at 1.435 inches (64.6–71.4 kg at 36.4 mm) 3. Thread sleeve puller into end of injection nozzle holder insert. Use slide hammer to remove insert. Part No. 575GC35 (E7 with Extarder) 190–210 lb. at 1.5 inches (86.2–95.3 kg at 38.1 mm) If spring force does not meet specification, discard and install new spring. Page 5-38 200 BENCH PROCEDURES 1. Spring tester J 22738-02 2. Valve spring 1. Arbor 2. Valve guides