Mack Trucks — 5-101.bk

5-101.bk Page 39 Friday, March 17, 2006 11:05 AM 1 2 200306a Figure 5-50 — Removing Injection Nozzle Holder Insert Figure 5-51 — Injection Nozzle Holder Insert Installation 1. Slide hammer J 2619-01 2. Sleeve puller J 29880 INJECTION NOZZLE HOLDER INSERT INSTALLATION [213 FH] Valve Yoke Guide Pins The valve yoke guide pins are located between valve guides. 1. Thoroughly clean insert bore and surrounding area before installing insert. 2. Apply Loctite 620 completely around the center of all three sealing diameters of the new insert. INSPECTION Inspect valve yoke guide pin surface for cracks or other damage. Also check pin diameter and installed height. Refer to Figure 5-51. 3.

Using nozzle sleeve installer J 29297 (2), drive insert (1) into cylinder head until it bottoms in lower counterbore face. Page 5-39 200 BENCH PROCEDURES 1. Insert 2. Nozzle sleeve installer J 29297