Mack Trucks — 5-101.bk

5-101.bk Page 45 Friday, March 17, 2006 11:05 AM Refer to Figures 5-57 and 5-58. Inlet and Exhaust Valve Installation The following (Figures 5-57 and 5-58) show a remanufactured cylinder head assembly ID and 20-degree intake valve ID. The inlet and exhaust valve head diameters are nearly the same size. It is important, therefore, that extra care be taken when assembling these valves. With the new, more effective valve stem seals (446GC328), pre-lubing the seals and valve stems during installation is extremely important. Perform the following: Valve Stem to Guide — If valves are removed, lubricate the inside diameter of the valve guides by using a “bottle brush” coated with graphite grease.

This is particularly important when both the valves and the valve guides are new. With an on-engine seal replacement, pre-lube the valve stems with engine oil while moving the valve up and down, prior to installation of the valve spring. Figure 5-57 — Remanufactured Cylinder Head Assembly ID Valve Stem to Seal Lip — The inside diameter of the seal lip and outside diameter of the valve stem should be well-lubricated with clean engine oil when installing the seal over the valve stem. It is essential that the J 42453 Valve Stem Seal Installation tool be used to install the seals.

This tool bottoms on the cylinder head rocker arm mounting bracket surface when the seal is installed to the proper depth on the valve guide. Using any non-bottoming type seal driver (such as a socket) may result in distorting the top surface of the seal casing which permanently distorts the seal lip and prevents proper sealing, or in the top rubber portion of the seal being cut off. Also, do not use seal installer J 41150, or seal damage will result. Tool J 41150 should be discarded immediately after receiving tool J 42453. Figure 5-58 — 20-Degree Intake Valve ID Refer to Figure 5-57. Any remanufactured cylinder head produced prior to 12/13/96 will not have the assembly ID stamped on it.

Heads which do not have assembly ID stamps are 30-degree intake valves and seats. Before installing valve stem seals, be sure the rotator has been installed. The rotator will not fit over the valve stem seal. Page 5-45 200 BENCH PROCEDURES