Mack Trucks — 5-101.bk

5-101.bk Page 46 Friday, March 17, 2006 11:05 AM 1. Lubricate the valve guides and valve stems with engine oil prior to installation. 2. Install valve spring lower washer (Roto-Coil), over valve guide. 3. Lubricate valve stem seals with engine oil and install seals using valve seal installer J 42453. 4. Install valve into cylinder head. 5. Check valve stem tip for nicks or burrs that may damage valve seal upon installation. 6. Install valve spring, upper washer and keepers. Use tool J 29294-B to install keepers. Figure 5-59 — Checking Valve Assembly Height Refer to Figures 5-59 and 5-60. 7. After valves are assembled, check each inlet valve for head height above cylinder deck.

The protrusion dimension for inlet valves should be 0.0425 ± 0.007 inch (1.0795 ± 0.178 mm). 8. Check each exhaust valve for head depth below cylinder deck. The depth dimension for exhaust valve should be 0.0414 ± 0.007 inch (1.0516 ± 0.178 mm), or 0.021 ± 0.007 inch (0.553 ± 0.178 mm) for Pyromet valves. Figure 5-60 — Inlet/Exhaust Valve Head Depth Measurement Page 5-46 200 BENCH PROCEDURES 1. Inlet valve 2. Depth/height measurement tool