Mack Trucks — 5-101.bk

5-101.bk Page 50 Friday, March 17, 2006 11:05 AM 4. Thread oil supply screw and O-ring (7) into bracket and torque to 5 lb-ft (7 N•m) using torque wrench J 24405 or equivalent. 10. Place center (second) rocker arm shaft bracket (4) and shaft (11) on a flat surface. This bracket does not have a threaded hole on top or an oil hole at bottom surface. Align mounting surface and offset of bracket with bracket that is already installed. 5. Lubricate inlet rocker arm (3) and install on rocker arm shaft. 6. Lubricate valve rocker arm adjusting screw and nut, and install into inlet rocker arm. 11.

Press shaft into rocker arm bracket until center lines of mounting holes in brackets are spaced 5.750 inches (146.050 mm) apart. 7. Assemble rocker arm retaining (coil) spring (6) on shaft. 8. Lubricate exhaust rocker arm (5) and install on rocker arm shaft. 9. Lubricate valve rocker arm adjusting screw and nut, and install into exhaust rocker arm (5). Figure 5-63 — Valve Rocker Arm Shaft Assembly (with Jacobs Engine Brake) Page 5-50 200 BENCH PROCEDURES 1. Snap ring 2. Flat spring 3. Inlet rocker arm 4. Brackets 5. Exhaust rocker arm 6. Spring 7. Locating/Jacobs oil supply screw and O-ring 8. Bracket with center threaded hole 9. Standard adjusting screws and jam nuts 10.

Jacobs adjusting screws and jam nuts 11. Shaft 12. Capscrews (long) 13. Capscrews (short) 14. Washers (for short capscrews) 15. Jacobs brake housing 16. Slave piston adjusters 17. Solenoid 18. Locations for long capscrews