Mack Trucks — 5-101.bk

5-101.bk Page 51 Friday, March 17, 2006 11:05 AM At this point, a used or scrapped cylinder head can be used as a template for proper bracket alignment and to ensure mounting surfaces of each bracket are parallel. 12. Lubricate inlet rocker arm (3) and install on shaft. 13. Assemble rocker arm retaining (coil) spring (6) on shaft. 14. Lubricate exhaust rocker arm (5) and install on shaft. 15. Place last (third) rocker arm shaft bracket (4) and shaft on a flat surface. This bracket does not have a threaded hole on top or an oil hole at bottom surface. Align mounting surface of bracket and offset with two brackets already installed.

Figure 5-64 — Solenoid Mounting Adapter O-Ring Refer to Figure 5-65. 3. Assemble solenoid mounting adapter into shaft and torque to 23–25 lb-ft (31–34 N•m) with crows-foot adapter and a calibrated torque wrench (J 24406 or equivalent). 16. Check for proper bracket alignment. Ensure that mounting surfaces of each bracket are parallel. Press shaft into rocker arm bracket. 17. Lubricate and install outermost inlet rocker arm (3). 18. Install flat spring and retaining snap ring on end of shaft to keep inlet rocker arm in place. 19. At opposite end of shaft, lubricate and install outermost exhaust rocker arm (5). 20.

Install flat spring (2) and snap ring (1) on end of shaft to keep rocker arm in place. Some rocker arm shafts are equipped with threaded plugs and aluminum washers instead of flat springs and snap rings. Figure 5-65 — Dynatard Engine Brake Solenoid Installation 21. Check all rocker arms to make sure they rotate freely. [266 KD] DYNATARD ENGINE BRAKE Dynatard Engine Brake Solenoid Dynatard Overload Protection (E7 Engines with Dynatard) Refer to Figure 5-64. 1. On valve rocker arm shaft assemblies with a Dynatard engine brake, install solenoid mounting adapter seal (O-ring) in counterbore in rocker shaft.

E7 engines built after January 1, 1992 and through mid-year 1993 are equipped with a Dynatard overload protection system. From mid- year 1993 through December 1993, E7 engines were built with either the Dynatard system or a Jake Brake . Mack Trucks, Inc. recommends installing the Dynatard overload protection system on all E7 engines built prior to January 1, 1992. This system consists of a 2. Lubricate solenoid mounting threads with clean engine oil. Page 5-51 200 BENCH PROCEDURES