Mack Trucks — 5-101.bk

5-101.bk Page 52 Friday, March 17, 2006 11:05 AM pressure relay switch and related hardware. Its purpose is to protect the Dynatard exhaust push rod from overload and from possibly bending during the transition from power mode to braking mode. An overload condition occurs when the turbocharger boost pressure in the inlet manifold is greater than 25 psi (172.4 kPa). The pressure delay switch momentarily restricts Dynatard engine brake activation if turbocharger boost inlet manifold pressure is above 24 psi (165.5 kPa). 4. Remove No. 16 undrilled cylinder head capscrew. 5. Lubricate and install cylinder head capscrew, with a drilled hole, in No. 16 location. 6.

Torque cylinder head capscrew to 205 lb-ft (278 N•m) using torque wrench J 24407 or equivalent. 7. Remove front 1/8 NPT pipe plug from inlet manifold. PARTS REQUIRED FOR OVERLOAD PROTECTION 8. Install new Dynatard pressure delay switch 1MR3532 into pipe plug opening and tighten with an open-end wrench. Dynatard pressure switch assembly 1MR3532* Engine brake wiring harness 41MR4381* 9. Install new Dynatard wiring harness 41MR4381 using the following steps: Engine brake switch jumper wire 41MR21252 a. Lubricate connector O-rings and snap connectors into cylinder heads. Cylinder head capscrew 400GC39M4* b. Connect Dynatard wire harness terminals to terminal post screws.

Pressure switch clamp screw 66AM2* Wiring harness strap 48RU2313P1* Wiring harness strap 48RU2313P2 c. Connect Dynatard wire harness terminal to Dynatard pressure delay switch connection and route wire through crossover loop connector between heads. Pressure switch clamp 83AX894* Engine brake switch harness bracket 72RU11120 10. Install valve covers. Engine brake switch harness clamp 83AX922 11. Reuse three clamps, 83AX922, from old engine brake harness and install on new brake harness at appropriate locations. Engine brake switch harness screw 64AM1 Engine brake switch harness washer 271AM5007 12.

Install clamp to Dynatard pressure delay switch wire and position Dynatard engine harness ground wire on clamp. Engine brake switch harness nut 157AM2 *Required parts for V-MAC applications. 13. Install capscrew through clamp to No. 16 drilled cylinder head capscrew to securely hold Dynatard pressure delay switch wire and ground wire. All parts listed are required for mechanical applications. 14. Attach wire tie(s) around Dynatard pressure delay switch wire and fuel return jumper line as needed. Dynatard Overload Protection System 15. Remove diode from existing Dynatard injection pump throttle switch. 16. Install jumper wire No. 41MR21252 to Dynatard injection pump throttle switch.

INSTALLATION (E7 MECHANICAL ENGINES) 17. Install fuel injection line L-shaped bracket to stud located on right side of engine block. Secure engine brake lead to this bracket. 1. Remove air cleaner ducting. 2. Remove cylinder head covers. 3. Remove existing engine brake harness. Page 5-52 200 BENCH PROCEDURES