Mack Trucks — 5-101.bk

5-101.bk Page 53 Friday, March 17, 2006 11:05 AM 18. Connect jumper wire to Dynatard engine brake harness connection. [266] ENGINE BRAKE SWITCH AND BRACKET ASSEMBLY 19. Attach wire tie around jumper wire and Dynatard switch bracket. Description 20. Test engine brake and check for leaks. Beginning in 1991, a cylinder block-mounted engine brake switch and mounting bracket assembly was released for E7 mechanically governed (non V-MAC) engines equipped with either a Jake Brake or Dynatard system (pre- 1994). The bracket design improves the service life of the switch by significantly reducing the engine vibration levels that the switch is subjected to.

This reduction in vibration levels is accomplished by relocating the mounting of the bracket from the rear of the injection pump to the auxiliary housing area of the cylinder block. Refer to Figure 5-65. INSTALLATION (V-MAC APPLICATIONS) 1. Connect engine brake wiring harness to connection located on right-hand side engine harness. 2. Secure connection to air compressor coolant line with wire tie. 3. Secure engine brake wiring to a clamp located on cylinder block near rear of injection pump. 4. Test engine brake and check for leaks. [266] JACOBS ENGINE BRAKE In mid 1992, an improved switch (part No. 1MR3529) was incorporated into the assembly.

This new switch, along with relocation of the bracket, adds significantly to the service life of the assembly. E7 engines built from mid-year 1993 through December 1993 were equipped with either a Dynatard engine brake or a Jake Brake. Since January 1, 1994, the Jake Brake has been used exclusively. Proper adjustment is essential. Over-adjustment of this switch arrangement will cause accelerated switch wear or switch failure. The Model 680B Jake Brake engine retarder is a vehicle-slowing device designed and approved for use on MACK E7 engines. Energizing the Jake Brake effectively converts a power- producing diesel engine into a power-absorbing air compressor.

This is accomplished by opening the cylinder exhaust valves near the top of the compression stroke, releasing the compressed air to exhaust. Adjustment (E7 Mechanically Governed Engine with Engine Brake) 1. Loosen the two screws holding the throttle switch to the switch bracket. Releasing compressed air to exhaust prevents the return of energy to the engine piston on the power stroke. The result is a net energy loss used to slow the vehicle. For more detailed information, specifications and repair procedures, refer to the appropriate Jacobs service manual. 2. Check the continuity by connecting a volt- ohmmeter across the switch terminals. 3.

Insert an 0.008-inch (0.203 mm) thickness gauge between the low idle screw and the idle lever. 4. Secure the throttle lever in the low idle position. 5. Slide the switch toward the throttle lever to the point where continuity is obtained. 6. Torque the two screws that hold the throttle switch to the switch bracket to 10 lb-in using torque wrench J 24405 or equivalent. Page 5-53 200 BENCH PROCEDURES