Mack Trucks — 5-101.bk

5-101.bk Page 54 Friday, March 17, 2006 11:05 AM 7. Remove the 0.008-inch (0.203 mm) thickness gauge and insert a 0.014-inch (0.356 mm) thickness gauge. There must be NO continuity with the 0.014-inch thickness gauge. [215 DW] OIL COOLER ASSEMBLY Description 8. Apply locking compound to the switch assembly nut after adjustment is correct. The oil cooler assembly is located near the left front of the engine. Engine coolant from the radiator flows through the lower radiator hose, into a chamber in the oil cooler. The coolant then flows into the water pump. The oil pump sends engine oil through the inlet port of the oil cooler into the cooling chamber.

Heat from the engine oil is transferred through the chamber walls to engine coolant. Cooled oil exits the oil cooler through the oil outlet port, flows through oil filters, and then into the engine. E7 engines feature a “removable-bundle” type oil cooler. Periodic visual inspection of the oil cooler will indicate condition of gaskets, O-ring and core. If a problem exists, these components can be serviced separately rather than replaced as an assembly. The presence of engine oil in the engine coolant may indicate internal engine problems or worn, loosened or damaged parts within the oil cooler. Continued operation under these conditions may result in severe engine damage.

Figure 5-66 — Engine Brake Switch and Bracket (Non V-MAC Engines) Page 5-54 200 BENCH PROCEDURES 1. Engine brake switch 2. Screw 3. Bracket