Mack Trucks — 5-101.bk

5-101.bk Page 56 Friday, March 17, 2006 11:05 AM Inspection 12. Torque coolant outlet end-cap capscrews to 20 lb-ft (27 N•m) using torque wrench J 24406 or equivalent. Refer back to Figure 5-67. 1. Visually inspect housing (24) for cracks which may cause a leak. Replace housing if damaged. Refer to Figure 5-68. 13. Pressure-check oil cooler for leaks by installing a test plate (4) with air fitting (3) as follows: 2. Check oil cooler bundle (22) for leaks by pressurizing with air to 80 psi (552 kPa) and submerging it in water. If a leak is detected, replace with new bundle. a. Position a rubber gasket (5) and test plate (4) on mounting flange (1) and secure with mounting capscrews (2).

Assembly Refer back to Figure 5-67. 1 Lubricate and install O-ring (3) in groove at coolant outlet end of oil cooler housing (24). 1. Apply Permatex gasket sealer on coolant inlet flange before installing gasket (23). 2. Install gasket (23) on coolant inlet end of housing (24). 3. Apply Permatex gasket sealer on top of gasket. 4. Install bundle (22). If necessary, tap bundle with soft-faced hammer to seat bundle past O-ring (3). 2 The alignment notch in the bundle end flange must be positioned at the top for proper installation. 5. Apply Permatex gasket sealer on bundle end. 4 5 2 3 6. Place gasket on bundle end. Figure 5-68 — Installing Test Plate 200275a 7.

Apply Permatex gasket sealer on top of gasket (21) before installing inlet cap (20). 8. Install coolant inlet end cap and secure with six capscrews (19). 9. Torque coolant inlet end-cap capscrews to 20 lb-ft (27 N•m) using torque wrench J 24405 or equivalent. Refer to Figure 5-69. b. Install a steel plate (2) with a rubber gasket on oil outlet opening. Secure to housing (1) with two capscrews (3). 10. Apply Permatex sealant to both sides of gasket (25) and install on mounting flange (4) of housing. c. Connect air line and pressurize to 80 psi (552 kPa). Submerge in water to check for leaks. 11. Install coolant outlet end cap (2) with six capscrews (26). Page 5-56 200 BENCH PROCEDURES 1.

Mounting flange 2. Capscrews 3. Air fitting 4. Test plate 5. Rubber gasket