5-101.bk Page 57 Friday, March 17, 2006 11:05 AM During engine operation, the impeller spins in proportion to engine speed. The spinning impeller blades create a negative pressure (suction) at the water pump inlet port and a positive pressure at the outlet port. Engine coolant is drawn into the water pump from the radiator, through the lower radiator hose. The impeller motion forces coolant to circulate through the engine block, cylinder head, and back to the radiator. When pressure-testing complete oil cooler assembly using an in-line pressure regulator, apply pressure at 2–5 psi (14–34 kPa) maximum. Then gradually increase pressure, checking for leaks until 80 psi (552 kPa) is reached.
To perform water pump service other than replacement, refer to the COOLING 7.0 manual. 1 [219 MU] OIL PUMP The shaft and pumping gear on oil pumps manufactured after February 1996 are a one- piece design. Earlier models have a gear pressed onto a keyed shaft. The shafts are interchangeable and replacement with a new (one-piece) shaft is recommended as oil pump gear-to-housing contact is reduced, resulting in longer pump life. Disassembly 2 Refer to Figure 5-70. 3 1. Remove pick-up tube and screen assembly (not shown). 2. Remove oil pump housing cover (7) from oil pump housing (4). 3 200276a Figure 5-69 — Sealing Oil Outlet 3. Remove oil pressure relief valve cap (13). 4.
Remove oil pressure relief valve spring (12) and plunger (11). 5. Slide oil pump idler gear (14) off shaft. [215 SW] WATER PUMP 6. Turn oil pump upside down and remove oil pump shaft nut (1) and washer (2). The water pump is a belt-driven centrifugal or impeller type, and is located on the front of the engine. The water pump pulley is belt-driven by the crankshaft pulley. 7. Using a press, remove drive gear (3) and key (5) from pumping gear and shaft assembly (6). 8. Remove pumping gear and shaft assembly from housing. 9. Remove oil pump inlet flange plate (9) and gasket (8) from housing by removing capscrews (10). Page 5-57 200 BENCH PROCEDURES 1. Housing 2. Plate 3. Capscrews