Mack Trucks — 5-101.bk

5-101.bk Page 59 Friday, March 17, 2006 11:05 AM 6. Insert pumping gear in housing and check for free play by spinning. If any binding occurs, check housing and gear teeth for burrs, nicks, or other damage. Replace as necessary. Before proceeding with assembly, check end clearance, side clearance, and backlash of drive gears as follows. END CLEARANCE CHECK Refer to Figure 5-71. 1. Low Limit — Place a straightedge across face of gears and run a 0.001-inch (0.025 mm) thickness gauge under straightedge. Gauge should move freely without binding. If binding occurs, check gears for nicks or burrs. Replace as necessary. 2.

High Limit — With straightedge in place (as in step 1), run a 0.007-inch (0.178 mm) thickness gauge under straightedge. Gauge should be very tight. If gauge moves freely, replace gears. Figure 5-71 — Oil Pump Driving/Idler Gear Assembly End Clearance Check Page 5-59 200 BENCH PROCEDURES 1. Thickness gauge 2. Straightedge 3. Pump driving gear 4. Pump driven gear