5-101.bk Page 60 Friday, March 17, 2006 11:05 AM SIDE CLEARANCE CHECK BACKLASH CHECK Refer to Figure 5-72. Refer to Figure 5-73. 1. Low Limit — Insert a 0.002-inch (0.051 mm) thickness gauge between side of gears and housing. Gauge should pass between gears and housing without drag. If it drags, check housing and gears for nicks or burrs. Replace as necessary. 1. Check backlash between driving gear (3) and driven gear (2) with thickness gauge (1). a. Low Limit — Insert a 0.013-inch (0.33 mm) thickness gauge (1) between pump driven gear (2) and pump driving gear (3). Gauge should pass between gears without binding. If binding occurs, check for nicks or burrs. Replace as necessary. 2.
High Limit — Insert a 0.006-inch (0.152 mm) thickness gauge between gears and housing. Gauge should not pass through. If gauge passes through, replace housing. b. High Limit — Insert a 0.028-inch (0.711 mm) thickness gauge (1) between pump driven gear (2) and pump driving gear (3). Gauge should not pass through. If gauge passes through, replace gears. 1 2 3 Figure 5-72 — Oil Pump Driving/Idler Gear Assembly Side Clearance Check Figure 5-73 — Checking Oil Pump Gear Backlash 200344a Page 5-60 200 BENCH PROCEDURES 1. Thickness gauge 2. Pump driven gear 3. Pump driving gear 1. Thickness gauge 2. Pump driven gear 3. Pump driving gear