5-101.bk Page 61 Friday, March 17, 2006 11:05 AM Improved “Fast Ratio” Auxiliary Driveshaft Refer to Figure 5-74. 1. Obtain a 1.5 fast ratio oil pump driving shaft gear (683GB284). An improved “fast ratio” auxiliary driveshaft assembly and oil pump assembly are in current production engines (effective February 27, 1992, serial No. 2E1233) and are available for service. These arrangements increase operating oil pressure by approximately 25%. 2. Restamp or etch new number on oil pump housing. “459M” on rear sump oil pumps “459M2” on front sump oil pumps Current “fast ratio” oil pump: With rear sump, part No. 315GC459AM With front sump, part No. 315GC459AM2 Drive gear (12 teeth), part No.
683GB284 Former “standard ratio” oil pump: With rear sump, part No. 315GC460AM With front sump, part No. 315GCA460AM2 459M Drive gear (13 teeth), part No. 683GB287 Do not mix “fast ratio” and “standard ratio” components. Serious damage may occur. STEEL STAMP LAST 4 DIGITS OF PART No."459M/M2" IN THIS AREA .125 LETTERS (BOTH VARIABLES) Short (quarter) blocks are stamped with the date of manufacture on the right rear side pad (for example, “2G”: 2G =199 2 , March). Short blocks stamped with “2G” or later (2H, 2K, 2L, etc.) are equipped with a 1.5 fast ratio auxiliary driveshaft assembly. It is critical that the matching oil pump also be fitted with a 1.5 fast ratio oil pump driveshaft gear.
200590a Figure 5-74 — Marking Oil Pump 3. Install a 1.5 fast ratio oil pump driving shaft gear on an old E7 oil pump. Torque retaining nut to 60 lb-ft (81 N•m). Torque cylinder block mounting screws to 40 lb-ft (54 N•m). A noncurrent 1.3 standard ratio E7 oil pump can be reused in combination with a 1.5 fast ratio auxiliary driveshaft assembly; however, several steps are necessary to modify the pump. It is possible to bolt a current 1.5 fast ratio oil pump driving gear in an engine with a noncurrent 1.3 standard ratio auxiliary driveshaft gear; however, serious damage will occur.
It is not physically possible to bolt a noncurrent 1.3 standard ratio oil pump driving gear in an engine with a current 1.5 fast ratio auxiliary driveshaft gear. Page 5-61 200 BENCH PROCEDURES