5-101.bk Page 62 Friday, March 17, 2006 11:05 AM Assembly 7. Install cover (7) on pump and secure with capscrews. Torque to 15 lb-ft (20 N•m). Refer back to Figure 5-70. 8. Install key (5) in driving shaft and gear assembly (6). 1. Install oil pressure relief valve plunger (11) in relief valve housing (4). 2. Install oil pressure relief valve spring (12) in relief valve housing. 9. Place gear (3) on shaft aligning slot with key on shaft. Press drive gear on shaft. 10. Install washer (2) and self-locking nut (1) on shaft. Torque to 60 lb-ft (81 N•m) using torque wrench J 24407 or equivalent. 3. Clean oil pressure relief cap (13) and install in relief valve housing. 11.
Install pickup tube and screen assembly. To maintain correct oil pressure for various oil system arrangements, the proper oil pressure relief valve spring and cap combination must be used. Using incorrect components may result in either high or low oil pressure, and contribute to premature engine damage. [221 CD] ECONOVANCE Econovance Control Valve Assembly Refer to Figure 5-74. The Econovance control valve assembly consists of a valve housing (7) and a solenoid valve assembly (6). 4. Install oil pump inlet flange cover (9) and gasket (8) on housing. Secure with capscrews (10).
The valve housing (7) contains oil passages to direct engine oil pressure to the Econovance, enabling the Econovance to perform the function of dynamically varying injection pump timing. 5. Install driving shaft and gear assembly (6) in housing and check for free spin. 6. Install idler gear (14) on housing shaft. The solenoid valve assembly (6) consists of a proportional solenoid controlled by the V-MAC module, which can position the solenoid anywhere within its range of travel; and a hydraulic spool valve, the position of which determines engine oil flow to the Econovance. The spool valve is not affected by the oil pressure it controls. The three O-rings on the spool valve are replaceable.
It is extremely important that pump application be checked prior to drive gear assembly. Several drive gears are available to establish correct oil pump-to-auxiliary drive gear ratio combination. Failure to select proper drive gear for application will result in gear and engine damage. Refer to Improved “Fast Ratio” Auxiliary Driveshaft in this section. Apply Loctite ® 271 to all capscrews used to assemble the oil pump. Page 5-62 200 BENCH PROCEDURES