Mack Trucks — 5-101.bk

5-101.bk Page 64 Friday, March 17, 2006 11:05 AM Cleaning and Inspection 1. Thoroughly clean inner sleeve and inner shaft with solvent and dry with compressed air. 2. Inspect inner sleeve and inner shaft for extreme wear, cracks or other damage. Replace as necessary. 3. Inspect outer shaft drive hub and seals. 4. Inspect Econovance housing. Econovance Assembly 1. Using clean engine oil, lubricate all gear surfaces. 2. Install Econovance spring (3) on inner shaft assembly (2). Make sure spring is properly seated. If not, binding will occur, causing damage to Econovance assembly. 3. Reinstall inner sleeve (4) on inner shaft assembly. Push down on inner sleeve until flush with lower seat.

To accomplish this, spring must be properly seated. Make sure sleeve does not bind on shaft. Figure 5-76 — Drive Hub Installation [221 KU] INJECTION PUMP DRIVE HUB 4. Reinstall inner sleeve and inner shaft assembly into outer shaft drive hub. Install outer shaft drive hub into Econovance outer housing (8), using new seal if needed. Description For mechanically governed engines, a scalloped- type drive hub is installed directly on the fuel injection pump camshaft. For V-MAC engines, the outer shaft drive hub, along with inner sleeve, spring and inner shaft assembly, is part of the Econovance unit.

It is linked to the fuel injection pump with a Celeron coupling or a two-piece metal-type coupling, depending on the date of production. 5. Reinstall retainer ring (1) in rear of Econovance assembly. 6. Apply Loctite 242 to drive-hub retaining capscrew (10) threads. Grooved side of hub retaining capscrew washer must face outer shaft drive hub (5). Special Tools Required Pump Holding Fixture J 37078 Refer to Figure 5-76. Injection Pump Drive Coupling Holder J 28452-A 7. Install outer shaft drive-hub retaining capscrew (10) and washer (9). Torque to 150 lb-ft (203 N•m) using torque wrench J 24407 or equivalent. Page 5-64 200 BENCH PROCEDURES