5-101.bk Page 65 Friday, March 17, 2006 11:05 AM Cleaning Degrease tapered surfaces of injection pump camshaft and drive hub with Stoddard No. 303 or Loctite 75559, or an equivalent degreasing agent. MACK E7 engines equipped with Bosch P7100 Series close-coupled injection pumps require a longer drive pump hub. Failure to degrease drive components prior to assembly may result in drive hub slippage. Do not install a key in the driveshaft. A key is not required and no keyway is provided in the hub. Installation of Drive Hub (Mechanically Governed Engines) Refer to Figure 5-78. Refer to Figure 5-77. 2. Install the flat washer and drive hub nut.
Torque to 200 lb-ft (271 N•m) using torque wrench J 24407 or equivalent. 1. Place injection pump into pump holding fixture J 37078. Turn pump drive hub to allow pump to be slid forward, engaging alignment pins until pump mounting surface is flush with fixture bracket. 3. Remove injection pump from holding fixture. The recess in the drive hub is now in position to clear the camshaft gear during installation. Figure 5-77 — Positioning Drive Hub and Pump in Fixture Figure 5-78 — Drive Hub Retaining Capscrew Installation Page 5-65 200 BENCH PROCEDURES 1. Holding fixture J 37078 2. Drive hub 3. Fuel injection pump