Mack Trucks — 5-101.bk

5-101.bk Page 66 Friday, March 17, 2006 11:05 AM Installation of Drive Hub (V-MAC Engines) Refer to Figure 5-81. 3. Using a suitable two- or three-jaw puller, remove the inner hub from the injection pump camshaft. DRIVE COUPLING REMOVAL A metal two-piece style drive coupling was introduced into production on certified E7 V-MAC engines built after July 1, 1992 — beginning with serial No. 2P and above. When the Celeron drive coupling requires replacement, replace with the two-piece style drive coupling. Refer to Figure 5-79. 1. Using injection pump drive coupling holder J 28452-A, securely hold injection pump outer coupling from turning while loosening coupling retaining nut.

Remove outer coupling. 200432a Figure 5-81 — Removing Inner Hub J 28452-A DRIVE COUPLING INSTALLATION 1. Install inner hub on injection pump camshaft. Do not install a key in injection pump camshaft. Keying of drive coupling (inner hub) to injection pump camshaft is not required and, if used, may result in damage. Figure 5-79 — Loosening Coupling Retaining Nut 200430a 2. Install coupling (inner hub) washer and retaining nut. Hand tighten. Refer to Figure 5-80. 2. Remove coupling (inner hub) retaining nut and washer. 3. Insert outer coupling on inner hub so hub- holding tool can be used to hold inner hub. The coupling may be installed in either direction.

A snap ring is installed in the splined bore of the outer coupling. Its function is to keep the outer coupling in proper position between the injection pump inner hub and the Econovance mating gear. 4. Using injection pump drive coupling holder J 28452-A, securely hold outer coupling. Torque coupling (inner hub) retaining nut to 200 lb-ft (271 N•m) using torque wrench J 24407 or equivalent. 200431a Figure 5-80 — Removing Retaining Nut and Washer Page 5-66 200 BENCH PROCEDURES