Mack Trucks — 5-101.bk

5-101.bk Page 2 Friday, March 17, 2006 11:05 AM GENERAL This section includes step-by-step procedures for complete assembly of the MACK E7 engine. Major components that were overhauled in the BENCH PROCEDURES section of this manual are reinstalled here as assemblies. Cleaning solvent is flammable and toxic to the eyes, skin and respiratory tract. Skin and eye protection is required. Avoid repeated or prolonged contact. Use only in well-ventilated area. Failure to follow the sequence of operations listed may result in damage to components or personal injury. Compressed air used for cleaning can create airborne particles that may enter the eyes or irritate the skin.

Pressure must not exceed 30 psi (207 kPa). Eye protection is required. Use only with effective chip guarding and personal protective equipment (goggles/ shield, gloves, etc.). After cleaning the components, properly store them where they will remain clean until needed for assembly. The purpose of component inspection is to determine which parts can be reused and which parts must be replaced. Use considerable judgment to make this determination. Cleaning the cylinder block is important. While cleaning the cylinder block, carefully inspect the areas around the cup plugs and the coolant jacket. If cup plugs or pipe plugs show signs of leaking, they should be replaced.

[211 DB] CYLINDER BLOCK Cleaning the cylinder block is a good time to inspect it for cracks or other possible defects that may be reason for rejection. Refer to TROUBLESHOOTING section of this manual for information on testing for leaks in the cylinder head and cylinder block. If damage is not found until after the engine is assembled, the engine must be disassembled and rebuilt again.

Special Tools Required Camshaft Bushing Installation/Removal Kit J 37713 Camshaft Bushing Remover/Installer J 21428-01 Counterbore Tool PT2210 Counterbore Cutter Plate PT2210-3A Hex Key Wrench PT2210-14 SOLVENT TANK CLEANING Universal Dial Depth Gauge PT5025 3-Inch Stylus Extension PT5025-11 Cleaning and Inspection Use a cleaning tank large enough to accommodate the largest component to be cleaned. Fill the tank with a suitable solvent and always use caution while cleaning parts. Parts may be dried with compressed air. The engine should have been thoroughly steam cleaned prior to component removal and the block should be relatively clean.

If heavy accumulations of dirt and grease are still present, steam clean the block as thoroughly as possible before attempting to clean with solvents. 1. Scrape any remaining gasket material from the block. Page 6-2 200 ENGINE ASSEMBLY