Mack Trucks — 5-101.bk

5-101.bk Page 3 Friday, March 17, 2006 11:05 AM 2. Using a wire brush or rotary wheel, remove any rust, corrosion or other debris from the block. If the cylinder block is determined to be serviceable after thorough cleaning and inspection, reassemble the engine. Use replacement or original parts, as determined during component inspection. 3. Clean all other block surfaces with mineral spirits or other suitable solvent. 4. Using due care and caution, clean and dry the block with compressed air. INSPECTION Cup Plug Replacement REMOVAL A complete discussion of the proper methods of precision measuring and inspection is outside the scope of this manual.

However, every shop should be equipped with standard gauges such as bore gauges, dial indicators, outside and inside micrometers, thickness gauges and straightedges. Refer to Figure 6-2. 1. Using a hammer and punch, drive one edge of the plug inward. The plug should rotate causing the opposite edge to move outward. When the edge moves out far enough, grab it with a pair of pliers and pull it out. Check the cylinder block for indications of cracking or coolant leakage. If any damage is suspected, use a standard dye penetrant or magnaflux procedure to determine if cracks exist. A cracked engine block must be replaced and never reused.

If, after several taps with a hammer, the plug does not rotate and is being driven inward, stop tapping. Drill a hole approximately 1/8 inch (3.2 mm) in diameter in the center of the plug. Insert a sheet-metal screw in the hole. Leave enough of the screw protruding from the plug to allow a pry bar to be inserted under the head of the screw and pry the plug out. Refer to Figure 6-1. Using a straightedge (PT5027 or equivalent) and thickness gauges, check the cylinder head mounting surfaces for flatness. The cylinder block mounting surface, on a service block, should be flat within 0.004 inch (0.102 mm). 2. Clean the plug hole(s) with a wire brush or wire wheel.

After cleaning, visually check the surface for cracks. When satisfied that there are no cracks anywhere in the block, replace the plug(s). Figure 6-1 — Checking Flatness of Cylinder Block Deck Page 6-3 200 ENGINE ASSEMBLY