Mack Trucks — 5-101.bk

5-101.bk Page 16 Friday, March 17, 2006 11:05 AM Refer to Figure 6-17. 1. Using piston cooling nozzle spray position set J 37721-A (pre-1991) or J 39045 (1991 and later), check the direction of the spray from the nozzles. 1 2 3 4 2. Position rod (6) in end of spray nozzle (7). 3. Place the applicable plastic target (1) on the cylinder block (2) over the cylinder to be tested. 4. Install a cylinder head bolt through the target alignment hole (3) and into the cylinder block capscrew hole (4) to align the target. 5 5. The rod (6) should now be aligned in the target area (5). If rod is at edge of target area, two methods may be tried to center the rod into the target area. 6 a.

Preferred — Loosen nozzle set screw. A slight adjustment can then be made to center the rod within the target area. Following adjustment, retorque set screw to 15 lb-ft (20 N m). 7 b. Alternate (pre-1991 only) — It is permissible to bend the hooked end of the nozzle tube only slightly to bring the rod fully within 1/8 inch of the target area. If more than 1/8 inch out of target area, replace nozzle. 200281a Figure 6-17 — Spray Nozzle Targeting Page 6-16 200 ENGINE ASSEMBLY 1. Plastic target 2. Cylinder block 3. Alignment hole 4. Cylinder block hole 5. Target area 6. Rod 7. Spray nozzle