Mack Trucks — 5-101.bk

5-101.bk Page 17 Friday, March 17, 2006 11:05 AM [211 HA] CYLINDER BLOCK DOWEL PINS The dowels used for timing gear cover installation are similar except for the size. The smaller dowels are used for the timing cover. The larger dowels are used for the flywheel housing. Description The diamond locating dowel pins used to install the front timing gear cover, flywheel and flywheel housing, have been replaced in production by blade-style locating dowel pins. The diamond pins were dual-diameter type pins with a smaller diameter at the round end that goes into the cylinder block. The blade-style pins are the same diameter at the round end and the blade end.

There are no changes in the size of the hole in the front timing cover. However, the cylinder block has a larger hole to accept the blade-style dowel pins. The cylinder block timing gear cover old pin number is 183GC221 and the new number, starting with serial number 2T (August 1992), is 183GC238. ROUND DOWEL PIN INSTALLATION Refer to Figure 6-18. 1. Insert round dowel pin (2) into the flywheel housing/timing cover locating pin driver J 37712 (1). The pin must be positioned in the driver with tapered end of the dowel facing outward. 2. Position exposed end of dowel into the left dowel pin hole (4) in cylinder block (3). 3.

Using a hammer, drive the pin into the block until the driver contacts the cylinder block. When the driver has made contact with the block, the dowel pin will be at the correct dimension above the block. Use a dowel size and type that is appropriate for the block being used. (Service old with old and new with new.) Install the blade-style dowel with the blade in a vertical direction (pointing up and down). Special Tools Required Flywheel Housing Diamond Dowel Aligner J 37711 Flywheel Housing/Timing Cover Locating Pin Driver J 37712 Removal If it is necessary to remove the timing cover or flywheel housing locating dowel pins, do so as follows: 1.

Securely clamp the pin with a pair of vise- grip pliers. Figure 6-18 — Round Dowel Pin Installation 2. While exerting an outward force, rotate pin back and forth until the pin works free from the hole. Installation Two precision-made dowel pins are used to locate the flywheel housing to the cylinder block. One dowel is round, the other is a diamond shape or blade type, as described earlier, depending on the production date. Page 6-17 200 ENGINE ASSEMBLY 1. Locating pin driver 2. Round dowel pin 3. Cylinder block 4. Dowel pin hole