Mack Trucks — 5-101.bk

5-101.bk Page 18 Friday, March 17, 2006 11:05 AM DIAMOND-SHAPED DOWEL PIN INSTALLATION BLADE-TYPE DOWEL PIN INSTALLATION Refer to Figure 6-19. 1. Position the round end of the blade-type dowel pin into the dowel pin hole in the cylinder block. The blade end must be aligned vertically with the block. 1. Position the two alignment studs (3) in the threaded holes (2) nearest the right dowel location hole (6) in the cylinder block (1). 2. Using a hammer, drive the dowel pin into the block until the shoulder of the pin is flush with the cylinder block surface. 2. Position the diamond-shaped dowel pin (5) in the diamond dowel aligner J 37711 (4). 3.

Position the diamond dowel aligner with the pin in position on the two alignment studs (3). 4. Using a hammer, drive the dowel pin into the hole until it bottoms out in the block. 5. Remove the diamond dowel aligner and the two alignment studs. The dowel pin will be at the correct height above the block. 3 1 2 4 5 6 2 3 200336a Figure 6-19 — Diamond-Shaped Dowel Pin Installation Page 6-18 200 ENGINE ASSEMBLY 1. Cylinder block 2. Threaded holes 3. Alignment studs 4. Diamond dowel aligner 5. Diamond-shaped dowel pin 6. Dowel location hole