5-101.bk Page 20 Friday, March 17, 2006 11:05 AM 3. Lubricate threads of the bearing capscrews with clean engine oil and place bearing capscrews in the bearing cap holes. Due to the considerable weight of the crankshaft, extreme care must be observed during installation. No nicks, scratches, burrs, or any other kinds of distress are acceptable on the main bearing and/or crankshaft journals and fillets. 4. Position cap in the correct location and start the screws in the threads. 5. Using a plastic-faced mallet, tap bearing cap down until it contacts the machined mounting surface. 6. Tighten the screws until they contact the bearing cap. At this time, tighten them only to finger tight. 6.
Using a suitable lifting device, position the crankshaft in the crankcase. [212 HH] MAIN BEARING CAP 7. Repeat above steps for remaining main bearing caps, except the center main bearing cap. Torque bearing cap capscrews to 210 lb-ft (285 N m) using torque wrench J 24407 or equivalent. Unfinished main bearing caps are available for servicing of E7 engines. These are undersize bore bearing caps for service rebore: Cap, Intermediate and Front Main Bearing (Semi-Finished), No. 223GB2131M Use standard thickness thrust washers initially. Refer to Figure 6-21. Cap, Rear and Center Main Bearing (Semi-Finished), No. 223GB2132 8. Place upper thrust washer sections in position at the center bearing.
The steel side of the thrust washer goes toward the block, the bronze side goes toward the crankshaft (this applies to upper and lower thrust washer sections). Special Tool Required Magnetic Base Indicator Tool J 7872 Installation 1. Clean bore in bearing cap and back of the lower bearing inserts. Beginning with October 1996 production, new- style thrust washers were introduced. These thrust washers are steel backed with an aluminum facing material on the side that goes against the crankshaft. As with the previous bronze-style thrust washers, the aluminum-faced thrust washers have oil reservoir grooves cut into the aluminum surface as well as tip face reliefs.
The aluminum thrust washers can easily be installed incorrectly because of the similarity of color between the steel backing and aluminum face. When installing aluminum-faced thrust washers, make sure the oil reservoir grooves and tip relief cuts are facing against the crankshaft. 2. Install bearing insert in bearing cap bore. The inserts must be installed dry. The lower bearing inserts do not have a hole or a notch. They are stamped with the word LOWER. Do not mix caps or inserts. The caps are numbered from 1 through 7, front to rear. Page 6-20 200 ENGINE ASSEMBLY