Mack Trucks — 5-101.bk

5-101.bk Page 21 Friday, March 17, 2006 11:05 AM The thickness of the thrust washers used in the bearing cap must match the thickness of the thrust washers in the block. Be sure to put the bearing surface of the thrust washer against the crankshaft when installing thrust washers. 16. Install the center main bearing cap, with bearing insert and the correct thrust washer sections in place, and torque the bearing capscrews to specification. 17. Recheck end play to make sure thrust washers have been installed correctly and end play is within specification. Rotate crankshaft to make sure there is no binding.

CHECKING RUNNING CLEARANCE Figure 6-21 — Crankshaft Thrust Washer Installation When using the Plastigage method of checking running clearance, do not turn the crankshaft. Doing so will destroy the Plastigage. 9. Position the lower section thrust washers on the center bearing cap (bronze/aluminum faces crankshaft) and install the cap. Torque capscrews to 210 lb-ft (285 N m) using torque wrench J 24407 or equivalent. 10. Install magnetic base indicator tool J 7872, or equivalent, on the block with the plunger against a crankshaft counterweight to check for crankshaft end play.

If checking the main bearing clearance with engine in the upright position (such as in the chassis), the weight of the crankshaft must be removed from the lower half of the bearing being checked. To do this, place cardboard under the crankshaft journal in the main caps adjacent to journal to be checked and tighten the adjacent caps until the journal to be checked seats against the upper bearing. Do not fully torque screws. Capscrews on bearing being checked should be torqued to specification after Plastigage strip has been positioned on the bearing shell. Support crankshaft at No. 1, 4 and 7 main journals, while checking No. 2, 3, 5 and 6 bearings. Support crankshaft at No.

3 and 5 while checking No. 1, 4 and 7 bearings. 11. Using a suitable pry bar, move crankshaft either forward or rearward until it stops. Tap end of the crankshaft with a plastic-faced hammer to seat the thrust washer. 12. Using pry bar, move crankshaft in the opposite direction. Tap end of the crankshaft with a plastic-faced hammer to seat the other thrust washer. 13. Set dial on the indicator to zero. 14. Using pry bar, move crankshaft in the opposite direction and read the dial indicator. Refer to the Fits and Limits chart for specifications. 15.

If end play is out of specification, remove thrust washers and install standard or oversize thrust washers, as required, to bring the end play into specification. Page 6-21 200 ENGINE ASSEMBLY