5-101.bk Page 22 Friday, March 17, 2006 11:05 AM Refer to Figure 6-22. 5. Remove capscrews and cap, and check the bearing running clearance. 1. Use Plastigage to check the main bearing clearance. Check each bearing, one at a time, by placing a piece of Plastigage on the journal and tightening the cap in place. The bearing clearance is determined by measuring the width of the crushed Plastigage with the supplied gauge. 6. Check width of the Plastigage using a Plastigage width chart. After measuring width, remove Plastigage from bearing. 7. If clearance is not within specification, correct as required. Be sure to use the correct size bearing. 2.
Place a section of Plastigage (2) on the journal to be checked and assemble main bearing cap (1) to cylinder block. 8. If clearance is less than specified, also check behind bearing for dirt, chips or burrs which would prevent the bearing from seating properly. 3. Apply a light coat of oil on threads of the bearing cap capscrews and secure cap. 9. Reposition cap on journal. Lubricate capscrews with clean EO-L specification engine oil. Lubricate and install the bearing cap buttress capscrews as required, and leave finger tight. Install the bearing cap capscrews and torque to 210 lb-ft (285 N m) using torque wrench J 24407 or equivalent. 4.
Torque capscrews to 210 lb-ft (285 N m) using torque wrench J 24407 or equivalent. The Plastigage strip will be crushed between the bearing insert (3) and the crankshaft journal (4). 1 2 Refer to Figure 6-23. 3 There are two buttress capscrew dimensions: LH side 2, 3, 5, 6; RH side 5, 6 (6 each) are 80 mm long (1) 4 RH side FRT 2 and 3, engine bulkhead (2 each) are 110 mm long (2) 200339a Figure 6-22 — Checking Running Clearance with Plastigage Page 6-22 200 ENGINE ASSEMBLY 1. Main bearing cap 2. Plastigage 3. Bearing insert 4. Crankshaft journal