Mack Trucks — 5-101.bk

5-101.bk Page 26 Friday, March 17, 2006 11:05 AM Refer to Figure 6-25. [211 HD] FLYWHEEL HOUSING 9. Check rod side clearance by installing a thickness gauge between rod and side of journal at the entire parting line area. Description Beginning in 1991, flywheel and flywheel housings for E7 engines equipped with standard transmissions incorporate engine timing and engine turnover features. In addition, new procedures and tools were introduced and must be used to ensure optimum performance, engine durability and emission compliance. Inspection Inspect the flywheel housing machined surfaces, capscrews, holes and dowel locations for cracks or wear. Replace if cracks are evident.

Before installing flywheel housing, examine crankshaft flange for any cracks, surface damage or presence of foreign particles. This type of damage could ruin the sealing capabilities of the new seal and lead to oil leakage. Dowel Pins The diamond locating dowel pins, used to install the front timing gear cover, flywheel, and flywheel housing, have been replaced in production by blade-style locating dowel pins. The diamond pins were dual-diameter type pins with a smaller diameter at the round end that goes into the cylinder block. The blade-style pins are the same diameter at the round end and the blade end. There are no changes in the size of the hole in the flywheel housing.

However, the cylinder block has a larger hole to accept the blade-style dowel pins. The old cylinder block flywheel housing pin number is 183GC219 and the new number, starting with serial No. 2T (August 1992), is 183GC237. Figure 6-25 — Connecting Rod Side Clearance Check 10. The clearance must be within specification shown in the Fits and Limits chart. If not, recheck for proper cap and rod alignment. Use a dowel size and type that is appropriate for the block being used. (Service old with old and new with new.) Install the blade-style dowel with the blade in a vertical direction (pointing up and down). Page 6-26 200 ENGINE ASSEMBLY