5-101.bk Page 27 Friday, March 17, 2006 11:05 AM Capscrews (Flywheel Housing) A variety of lengths of flywheel housing-to- cylinder block capscrews are used. Also, different sized flat washers are used depending upon whether a ductile iron or aluminum flywheel housing is being installed. The following illustrations show where the different length capscrews should be installed in various flywheel housings. For standardization purposes, the E7 E-Tech™ flywheel housing castings are now being used on the E7 engine. Production phase-in began mid- October 1996. Along with the new flywheel housing, a standardization of the flywheel housing mounting hardware also took place.
For all new-style housings used on the E7 engine, use the following mounting hardware: Refer to Figure 6-26. Two upper external mounting location capscrews — M3 (3 inches long). Six internal mounting location capscrews — M (2 inches long). On flywheel housing-to-cylinder block capscrew, No. 429GC23M, the dash suffix denotes the length of the capscrew. Eight washers used with aluminum housing — Part No. 35AX1489. -M3 is 3 inches long, -M2 is 2-9/16 inches long, -M5 is 2-3/8 inches long, -M is 2 inches long, and -M4 is 1-3/4 inches long. Eight washers used with ductile iron housing — Part No. 271AM5008. Flat washers: 271AM5008, approximately 3/16-inch thick.
Use with ductile iron flywheel housing. Service replacement flywheel housings will be the standardized flywheel housing. If an existing, older E7 flywheel housing is replaced with the newer standardized housing, the six (429GC23M) two-inch capscrews must be used at the internal mounting locations. If the older, various-length mounting bolts are used to mount the new-style housing, thread engagement is insufficient for some of the shorter bolts, and the longer bolts bottom in the cylinder block mounting holes, causing damage to the threads. The new appropriate mounting hardware comes with the new-style flywheel housing supplied by the MACK Truck Parts System.
711GC1100P7, approximately 5/16-inch thick. Use with aluminum flywheel housing. 35AX1489, used with newer standardized aluminum flywheel housing. Page 6-27 200 ENGINE ASSEMBLY