Mack Trucks — 5-101.bk

5-101.bk Page 29 Friday, March 17, 2006 11:05 AM Installation 4. Apply an even coat of Silastic (approximately a 1/16-inch [2 mm] bead) to the flywheel housing mounting surface of the cylinder block. Refer to Figure 6-28. 1. Remove the rear crankshaft oil seal from the flywheel housing by drilling two 3-mm holes 180 degrees apart into the outer edge of the seal. Remove the seal with a slide hammer fitted with a No. 10 sheet-metal screw. Thread it into each of the holes alternately and work the seal free. 2. Using standard shop cleaning procedures for aluminum, clean the seal mounting surface. 3. Insert the two dowel pins in the cylinder block if they were removed. Refer to Figure 6-27. 5.

Align the flywheel housing on the dowels and position it flush against the cylinder block surface. Refer to Figure 6-29. Figure 6-28 — Applying Sealant Figure 6-27 — Flywheel Housing Installation Figure 6-29 — Positioning Flywheel Housing The flywheel housing dowels maintain the alignment of the flywheel housing on the engine. This is necessary to center the transmission with respect to the engine flywheel and crankshaft. Page 6-29 200 ENGINE ASSEMBLY 1. Cylinder block 3 2. Flywheel housing 4 . Dowel pin . Capscrews