Mack Trucks — 5-101.bk

5-101.bk Page 30 Friday, March 17, 2006 11:05 AM 6. Install the exposed flywheel mounting capscrews and tighten them finger tight. 7. Torque all flywheel housing capscrews to 170 lb-ft (231 N m) using torque wrench J 24407 or equivalent. Refer to Figure 6-30. Figure 6-30 — Torquing Flywheel Housing Capscrews Runout With the machined dowel method of installation, flywheel housing runout is well within the old service specification of 0.010 inch (0.254 mm) Total Indicated Runout (TIR), when checked with an alignment bar through the cylinder block main bearing bores.

However, when checking flywheel runout using a dial indicator on the crankshaft rear flange or the flywheel, results may exceed 0.010 inch (0.254 mm) due to factors such as crankshaft movement within the bearing clearances and other variables. Figure 6-31 — Flywheel Housing Runout Check with Alignment Bar Flywheel housing runout specifications are as follows: Runout checked with an alignment bar installed through the cylinder block main bearing bores: 0.010 inch (0.254 mm) TIR maximum. Refer to Figure 6-31. Runout checked with a dial indicator mounted on the crankshaft rear flange or flywheel: 0.020 inch (0.508 mm) TIR maximum.

This way, the runout may appear to be excessive due to crankshaft movement within bearings and other variables. Refer to Figure 6-32. Figure 6-32 — Flywheel Housing Runout Check with Dial Indicator (PT5035) and Z adapter (PT5035-1) Page 6-30 200 ENGINE ASSEMBLY