Mack Trucks — 5-101.bk

5-101.bk Page 31 Friday, March 17, 2006 11:05 AM [212 JH] CRANKSHAFT WEAR RING When the service oil seal is to be replaced and the crankshaft flange is worn, the crankshaft can be salvaged by installing a crankshaft wear ring. An oil seal with a larger inside diameter is used with this wear ring. Special Tools Required Crankshaft Rear Seal Installer J 37716-A Wear Ring Installer J 38880 Universal Driver Handle J 8092 Removal Figure 6-33 — Crankshaft Wear Ring Removal Installation Refer to Figure 6-34. A limited number of crankshafts were manufactured with a repair sleeve installed on the flange. The repair sleeve is usually not noticeable and is finish ground to standard flange size.

If the repair sleeve is damaged or becomes loose, the crankshaft must be replaced. On some wear rings it may be difficult to determine the direction of the arrow on the inside diameter. In this case, ensure proper installation by installing the wear ring with the chamfer on the inside diameter toward the engine. The chamfer on the outside diameter of the wear ring must face away from the engine. Special care must be taken not to damage the crankshaft flange during wear-ring removal. Refer to Figure 6-33. 1. The wear ring can be removed by carefully applying heat, using a ball-peen hammer to expand the diameter, or by using a chisel to split the wear ring.

Use extreme care not to damage the crankshaft flange. The crankshaft wear ring is shrink fit on the crankshaft flange. Use wear ring installer J 38880 and universal driver handle J 8092 to install the ring to the proper depth. Place chisel face squarely on wear ring. Use careful blows to cut wear ring only and not damage crankshaft flange. The wear ring will become loose enough to remove without cutting it completely through. The goal is to carefully remove the wear ring in this manner and not cut, nick, or damage the crankshaft flange. 2. Thoroughly clean the flange area of the crankshaft. Check for nicks or scratches and repair any damaged areas with crocus cloth as necessary.

Figure 6-34 — Proper Crankshaft Wear Ring Installation Page 6-31 200 ENGINE ASSEMBLY