Mack Trucks — 5-101.bk

5-101.bk Page 32 Friday, March 17, 2006 11:05 AM 1. Position wear ring in the spring clips of the wear ring installer J 38880 with the arrow pointing away from the installer tool. Wear Ring with Double-Lip Teflon Seal (Automatic Transmission) The oversize inside diameter lip seal and wear ring are shipped as an assembly, with the seal installed on the wear ring. Do not remove the seal from the wear ring prior to installation. The wet clutch wear ring and seal installer J 35529 is required for installation. This tool presses both the wear ring and the oil seal onto the crankshaft flange. Do not heat the wear ring with a torch. This type of heat source will not heat the ring evenly. 2.

Heat the wear ring and wear ring installer together in a temperature-controlled oven or on a hotplate, with the wear ring on the bottom and installed in the spring clips of the installer. Work as close as possible to the engine to avoid heat loss after heating ring. Heat to 400°F (205°C). Do not install the driver handle at this time. This allows the wear ring to maintain sufficient heat until it is fully installed on the crankshaft flange. SPECIAL TOOL REQUIRED Wear Ring and Seal Installer J 35529 INSTALLATION Refer to Figure 6-36. 1. Remove existing wear ring from crankshaft before installing new wear ring. 3. Thoroughly clean and dry the crankshaft oil seal mounting flange. 2.

Thoroughly clean and dry the crankshaft flange. 4. After the wear ring is sufficiently heated, use heat-resistant gloves to install the universal driver handle J 8092 into the threaded hole in the center of the installation tool. 3. Apply a thin, even layer of Loctite 609 to the circumference of the crankshaft flange. 5. Remove the wear ring and installation tool from the oven or hot plate and immediately position the wear ring and installation tool over the crankshaft flange until the installation tool is fully seated against the end of the flange. As the wear ring cools, it will shrink fit onto the crankshaft flange. Refer to Figure 6-35.

Do not lubricate the lips of a Teflon seal before installation. Teflon seals function most effectively when installed dry. 4. The lip of one side of the seal is yellow. Install the oil seal with the yellow lip toward the transmission. Position the oil seal and wear ring assembly onto the recessed side of the installation tool adapter plate with the yellow lip facing away from the direction of installation (toward the transmission). 6. Allow the wear ring to cool completely. Then remove the installation tool. 5. Using the three guide pins, attach the oil seal installation tool adapter plate to the crankshaft flange. 6.

Install the press cup over the guide pins, then install the press cup driver hex nut. Figure 6-35 — Crankshaft Wear Ring Installation Page 6-32 200 ENGINE ASSEMBLY