5-101.bk Page 33 Friday, March 17, 2006 11:05 AM 7. Tighten the hex nut until a positive stop is felt. At that point, the oil seal and wear ring are properly installed on the crankshaft flange. Special handling precautions must be taken while installing Teflon seals. Do not lubricate the lips of a Teflon seal before installation. Teflon seals function most effectively when installed dry. 8. Remove the installation tool. 1. Thoroughly clean the surface of the crankshaft flange. 2. Position the oil seal (2) and installation sleeve (3) onto the recessed side of the J 37716-B oil seal installation tool adapter plate (1). The single-lip seal must be installed with the lip toward the engine.
Refer to Figure 6-37. Figure 6-36 — Crankshaft Wear Ring (with Double-Lip Teflon Seal) Installation Using J 35529 [212 JH] CRANKSHAFT REAR OIL SEAL In November 1992, MACK introduced Teflon oil seals into E7 production. E7 engines with dry flywheel housings (standard transmission) use single-lip seals. Replacement seals are available in Viton or Teflon. Viton seals are available with an oversized inside diameter and the wear ring is installed in the seal. E7 engines with wet flywheel housings (automatic transmission) use double-lip seals, which are available in Teflon only. Figure 6-37 — Crankshaft Rear Oil Seal Installation 3.
Using the three guide pins, attach the adapter plate to the crankshaft flange. Refer to Figure 6-38. Installation Standard-size Teflon seals are shipped on a plastic installation sleeve. Do not remove the sleeve from the seal before installation. The installation sleeve provides a smooth surface for the seal as it moves from the tool to the crankshaft flange. Crankshaft design allows the single-lip seal to be installed at the production depth of 0.344 inch ± 0.005 inch (8.74 mm ± 0.127 mm), or a service depth of 0.250 inch ± 0.005 inch (6.35 mm ± 0.127 mm) from the outer edge of the crankshaft flange.
Figure 6-38 — Adapter Plate J 37716-B Installation The double-lip seal must be installed to a depth of 0.250 inch ± 0.005 inch (6.35 mm ± 0.127 mm) only. This is the only installation depth specified for a double-lip seal. Page 6-33 200 ENGINE ASSEMBLY 1. J 37716-B 2. Oil seal 3. Installation sleeve