5-101.bk Page 34 Friday, March 17, 2006 11:05 AM 4. Determine the seal and wear ring installation depth: 5. The two installation depths are stamped above two of the guide pin bores of the installation tool press plate. To install the seal to the desired depth, position the press plate so that the guide pins go through the bore stamped with the desired depth. New seal on new crankshaft — Install to initial production depth of 0.339–0.349 inch (8.611–8.865 mm). New seal on service crankshaft — Install to service depth of 0.245–0.255 inch (6.223–6.477 mm). 6. Install the press plate driver hex hut and continue tightening until a positive stop is felt.
At this point, the seal is installed to the proper depth. Wear ring installation depth — 0.15–0.220 inch (5.461–5.588 mm). Service oil seal installation depth with new wear ring — 0.339–0.349 inch (8.611–8.865 mm). 7. Remove the installation tool. Service oil seal installation depth with used wear ring — 0.245–0.255 inch (6.223–6.477 mm). Refer to Figure 6-39. Figure 6-39 — Crankshaft Rear Oil Seal Page 6-34 200 ENGINE ASSEMBLY 1. Crankshaft rear oil seal 2. Production installation depth 3. Service oil seal installation depth 4. Service oil seal installa- tion depth with wear ring 5. Wear ring installation depth