5-101.bk Page 37 Friday, March 17, 2006 11:05 AM [213 CH] CAMSHAFT Special Tools Required Description Tappet Holders J 37720-B Camshaft Removal/Installation Tool J 41461 Refer to Figure 6-42. Inspection The E7 camshaft design uses large journals to decrease bearing loading and to allow for larger, more durable cam lobes. In addition, the profile of the exhaust lobes has been changed (with part No. 5205) to increase the duration of exhaust valve opening. Both the camshaft driven gear and the fuel injection pump driving gear are pressed onto the shaft. 1. Thoroughly clean the camshaft. 2. Inspect the camshaft cam lobes.
Replace the camshaft if cam lobes show evidence of cracking, pitting or scoring. To provide increased duration for the exhaust valve opening, the exhaust lobe profile for cam part No. 5205 is flatter across the nose portion compared to traditional MACK cams. Do not misinterpret this flatter profile design as an improperly machined or worn lobe. The 5205 cams can be identified by the 3 grooves in the shaft between the No. 11 and No. 12 lobes. Refer to Figure 6-43. Figure 6-43 — Camshaft Identification, Part No. 454GC5205 3. Inspect the journals. Replace the camshaft if the journals are scored or worn. 4. Use standard magnaflux inspection procedures to detect cracks.
MINIMUM ACCEPTABLE CAM LOBE LIFT Figure 6-42 — Camshaft Contours Intake Lobe 0.300 (7.62 mm) 0.270 inch 0.280 inch (7.112 mm) Page 6-37 200 ENGINE ASSEMBLY Camshaft Part No. Exhaust Lobe I 454GC583, 454GC583A 0.300 inch 0.3 (7.62 mm) 454GC5142 0.300 inch 0.2 (7.62 mm) (6. 454GC5205 0.300 inch 0.2 (7.62 mm) (7.