5-101.bk Page 38 Friday, March 17, 2006 11:05 AM Installation (Engine in Stand) 4. Lubricate the camshaft journals and the camshaft bearing surfaces with clean engine oil. 1. With the cylinder block in the stand, rotate the stand so that the crankcase is upward (engine inverted). Refer to Figure 6-45. 2. Rotate the crankshaft so that the drive gear timing mark is aligned with the camshaft opening. Refer to Figure 6-44. 5. Carefully insert the camshaft into the block using installation guide tool J 41461. Align the timing marks on the camshaft with the timing mark on the main crankshaft drive gear.
The use of the installation tool will make it easy to slide the camshaft into the block while protecting the cam and bushings from damage. Figure 6-44 — Crankshaft Drive Gear Alignment Arrange valve lifters so that they can be identified and reinstalled into the same hole from which they came. 3. Clean the valve lifters, lubricate by dipping the shaft of the valve lifter in clean engine oil, and insert into the valve lifter holes in the block. 200313a Figure 6-45 — Alignment of Timing Marks 6. Secure the camshaft captured thrust washer to the block using the two patch-lock 12-point capscrews and hardened washers. Torque to 15 lb-ft (20 N m) using torque wrench J 24406 or equivalent.
Visually check the camshaft to be sure that the two camshaft gears and the captured thrust washer are in place on the shaft. Page 6-38 200 ENGINE ASSEMBLY