5-101.bk Page 39 Friday, March 17, 2006 11:05 AM Installation (Engine in Chassis) J 37720-B In order to use the valve lifter tool to hold the valve lifters in position, the cylinder heads must be installed on the engine. Arrange valve lifters so that they can be identified and reinstalled into the same hole from which they came. 1. Rotate the crankshaft so that the drive gear timing mark on the drive gear is aligned with the camshaft opening. Refer back to Figure 6-44. 201180a Figure 6-46 — Tappet Holder Tool 5. Perform steps 3 and 4 on each of the remaining valve lifters. 2. Clean the valve lifters. Lubricate valve lifters by dipping the shaft in clean engine oil.
Visually check the camshaft to be sure that the two camshaft gears and the captured thrust washer are in place on the shaft. With the engine in the chassis, the valve lifters must be held in the UP position, using tappet holders J 37720-B. Refer to Figure 6-47. 3. Insert the valve lifter into the valve lifter holes provided in the block. As the lifter is installed, it must be held in position by inserting a tappet holder into the opening through the top of the cylinder block. The tappet holder must be positioned so that the magnetic head of the tool holds the lifter in position. Check to see if the tool has captured the valve lifter by drawing upward on the tool.
A resistance will be felt that cannot be felt if the magnet has contacted something other than a valve lifter. 6. Insert camshaft removal/installation tool J 41461 (3) into position on the rear segment of the camshaft (1) by snapping the clip (2) into position. 1 2 4. Secure the lifter in the UP position with grommets provided in the tappet holder. The holding tool shafts of two adjacent valve lifters can be prevented from dropping by wrapping a rubber band around the two shafts. This draws the shafts together and holds them in position. Refer to Figure 6-46. 3 Figure 6-47 — Camshaft Removal/Installation Tool 200573a Page 6-39 200 ENGINE ASSEMBLY 1. Rear segment of camshaft 2.
Tool retaining clip 3. Camshaft installation/ removal tool J 41461