5-101.bk Page 40 Friday, March 17, 2006 11:05 AM 7. Lubricate camshaft journals and camshaft bearing surfaces (in cylinder block) with clean engine oil. Refer to Figure 6-48. 9. Secure camshaft captured thrust washer to the block using the two patch-lock 12-point capscrews (3) and hardened washers. Torque to 15 lb-ft (20 N m) using torque wrench J 24406 or equivalent. Do not rotate camshaft with the installation tool in position on the shaft. The tool must remain on the bottom of the shaft (6 o’clock position) or it will not function properly. 1 8. Carefully insert camshaft into the block with the camshaft installation tool in place.
Align timing marks on the camshaft with timing mark on the main crankshaft drive gear. Refer back to Figure 6-45. 2 The use of the installation tool will make it easy to slide the camshaft into the block while protecting the cam and bushings from damage. 3 3 4 200365a Figure 6-48 — Camshaft Installation 10. Remove the camshaft removal/installation tool. Page 6-40 200 ENGINE ASSEMBLY 1. Thrust washer 2. Openings 3. Capscrew, 12-point 4. Camshaft drive gear