5-101.bk Page 44 Friday, March 17, 2006 11:05 AM [211 RP] TIMING GEAR COVER Apply Loctite 271 to all capscrews used to assemble the oil pump. With the crankshaft, camshaft and auxiliary driveshaft in place, install the timing gear cover. Remove the injection pump cover from the timing cover to allow access to the injection pump drive gear during injection pump installation. 3. If the pump was disassembled and is now securely mounted in position, torque all capscrews on the pump as follows: Plate, 15 lb-ft (20 N m) For all E7 engines that do not use the front timing boss, a new timing gear cover (No. 333GB5123M2) is available without the timing boss.
The new timing gear cover has a reduced possibility of cracking. For E7 engines requiring front timing, the old timing gear cover (No. 333GB5123M) is still available. Sump, 35 lb-ft (47 N m) Relief valve cap, 80 lb-ft (108 N m) Housing cover, 15 lb-ft (20 N m) After the auxiliary driveshaft has been installed, check the backlash between the auxiliary driveshaft gear and the oil pump drive gear. 1. Apply a light coat of Silastic to the timing- cover mounting surface. 2. Position the timing cover on the cylinder- block mounting surface. 4.
Check the oil pump drive gear to oil pump driven gear backlash, 0.0072–0.0138 inch (0.1829–0.3505 mm), using a thickness gauge between the auxiliary driveshaft gear and the oil pump drive gear. Some mounting capscrews cannot be installed until the injection pump is installed. 3. Secure the timing cover to the cylinder block using the mounting capscrews. Torque the capscrews to 40 lb-ft (54 N m) using torque wrench J 24407 or equivalent. 4. Position the front pedestal mount on the timing cover and secure with the mounting hardware. Torque the pedestal mounting capscrews to 70 lb-ft (95 N m) using torque wrench J 24407 or equivalent. Page 6-44 200 ENGINE ASSEMBLY