Mack Trucks — 5-101.bk

5-101.bk Page 45 Friday, March 17, 2006 11:05 AM [211 SB] TIMING GEAR COVER SEAL [221 GP] FUEL INJECTION PUMP INSTALLATION Special Tool Required Refer to SETUP AND ADJUSTMENTS section under Fuel Injection Fixed-Timing Procedures for pump installation procedure. Crankshaft Front Seal Installer J 37715-A Installation [212 RH] CRANKSHAFT HUB Refer to Figure 6-52. 1. To install the lip-type seal, use crankshaft front seal installer J 37715-A. Position the seal on the tool, with the solid portion of the seal outward (toward the tool). Inspection Inspect the crankshaft hub for scoring and condition of flange, threaded holes and keyway. 2. Position the tool over hub and into the seal opening.

Replace the hub if the seal shows signs of wear. Mack Trucks, Inc. does not recommend the use of a service sleeve to repair the crankshaft hub when there is hub damage. When there is damage to the hub, replace it. Installation Refer to Figure 6-53. 1. Insert hub key in keyway of the crankshaft. 2. Using a suitable grease-type lubricant, coat the working surface of the seal in preparation for crankshaft hub installation. Teflon-type seals do not require greasing the seal working surface of the crankshaft hub. 3. Heat hub to approximately 250°F (121°C) prior to installation. 4. Using heat-resistant gloves, align keyway in the hub with key in the shaft.

Figure 6-52 — Timing Gear Cover Seal Installation 1. Timing gear cover seal 2. Seal installer J 37715-A 3. Timing gear cover When engine has flywheel timing, the crankshaft hub will not have a keyway slot. 3. Insert the hub capscrew into the hole in the seal installation tool and draw the seal in until the tool bottoms out on the face of the crankshaft. 5. In a quick, even motion, push the hub onto to the crankshaft. 6. Install hub washer and capscrew. Tighten capscrew to 330 lb-ft (447 N m) using torque wrench J 23775-01 or equivalent. 4. Remove the tool and check the seal to make sure it has been evenly installed. Page 6-45 200 ENGINE ASSEMBLY