Mack Trucks — 5-101.bk

5-101.bk Page 46 Friday, March 17, 2006 11:05 AM Inspection Inspect the vibration damper for dents, nicks or fluid leaks in the outer housing. If any of the above are evident, the vibration damper must be replaced. Due to the close clearances between the damper housing and its internal flywheel, dents or nicks may cause contact between the two components. Fluid loss will deteriorate the dampening effect of the damper. Installation Figure 6-53 — Crankshaft Hub/Vibration Damper 1. Position the vibration damper and drive pulley on the crankshaft hub. 2. Secure with six mounting capscrews. Torque screws to 45 lb-ft (61 N m).

[211 NB] OIL PAN [212 RB] VIBRATION DAMPER Description (Isolating Oil Pan Gasket on E7 Engines) Description Reducing oil pan vibration is an important step in reducing engine noise and ensuring oil pan integrity, especially at the high power levels of today’s engines. For this reason, the isolating oil pan gasket arrangement introduced early in 1994 will gradually be phased into all engine and chassis models. The vibration damper is mounted to the front of the engine crankshaft hub and secured with six capscrews. The viscous-type vibration damper consists of a flywheel (inertia mass) enclosed in a fluid-tight housing.

The vibration damper flywheel and the housing are separated by a thin layer of viscous fluid that is not affected by temperature changes. Any movement of the inertia mass is resisted by the friction of the fluid, which tends to dampen excessive torsional vibrations in the crankshaft. Most noticeable among the changes in this arrangement are the use of a 1/4-inch (6.35 mm) thick rubber gasket and the elimination of the reinforcement strip on the pan rail and the belly bands on the oil pan. The thicker, more conformable isolating gasket will substantially improve sealing, especially over a long period of time.

The vibration damper must be removed whenever the crankshaft front seal, timing gear cover or crankshaft are removed. Serviceability is also improved. When the oil pan is removed, unlike the fiber gasket, it is not necessary to scrape the gasket from the cylinder block and the oil pan. In fact, the new gasket, in most cases, can be reused. When removing or handling the vibration damper, be careful not to damage the housing. Any dents in the damper outer case may render the vibration damper ineffective. An ineffective vibration damper may result in crankshaft cracks. The vibration damper cannot be repaired. Page 6-46 200 ENGINE ASSEMBLY 1. Crankshaft 2. Key 3. Crankshaft hub 4.

Vibration damper 5. Pulley 6. Hub capscrew 7. Damper/puller capscrews