5-101.bk Page 50 Friday, March 17, 2006 11:05 AM Oil Pan Installation 1. Clean any oil from the cylinder block mounting surface and the oil pan rail. The oil pan must be installed dry. 1 Oil on the surface of the gasket or the rails of the cylinder block and oil pan during oil pan installation can cause the gasket to bulge out between any two bolts, particularly those at the mid-section corners. This condition may not occur immediately, but can do so at any time after installation. To avoid this occurrence, wipe any oil from the inner walls of the cylinder block crankcase and then clean the rails of the cylinder block and oil pan with a solvent such as lacquer thinner.
Dry the cleaned surfaces completely. 3 MAKE SURE THERE IS CLEARANCE BETWEEN THE OIL PAN AND THE METAL ISOLATING WASHER. 2. Position the isolating oil pan gasket on the oil pan rails with ribbed side facing up. 2 3. Beginning at the center of the pan at one of the rectangular tabs, align rubber locating cones with corresponding holes in the oil pan rails. 200576a Figure 6-57 — Checking Clearance 4. In one motion, firmly press upper portion of the gasket with one hand while carefully pulling the rubber cone through the hole with the other hand until seated. Continue this procedure for the remaining locating cones.
OIL PAN INSTALLATION WITH NEW E7 CYLINDER BLOCKS Part numbers for E7 cylinder blocks with 8-mm tapped holes in the pan mounting rail are listed below. These are the service replacements for cylinder blocks with 10-mm tapped holes in the cylinder block oil pan rail. 5. After all cones have been installed, recheck to ensure they are all properly seated. Cylinder Block Assembly No. 239GB5517M During removal of the isolating oil pan from the engine, the studs may have backed out while loosening the stud nuts. Be sure they are fully seated prior to installing oil pan. Cylinder Block Service Assembly No.
239GB5494C With the introduction of these cylinder blocks, blocks with the 10-mm tapped holes in the cylinder block oil pan rail are no longer available. 6. When installing oil pan onto the engine, center the pan before tightening fasteners so that the edges of the metal isolator washers do not touch the pan. Refer to Figure 6-57. The isolating oil pan gasket arrangement can only be used with cylinder blocks, timing gear covers and flywheel housings that have 8-mm tapped holes in the oil pan rail. Page 6-50 200 ENGINE ASSEMBLY 1. Cylinder block 2. Oil pan 3. Rubber gasket