Mack Trucks — 5-101.bk

5-101.bk Page 51 Friday, March 17, 2006 11:05 AM OIL PAN INSTALLATION WITH NEW E7 TIMING GEAR COVER AND FLYWHEEL HOUSING When servicing any engine with the fiber oil pan gasket (8-mm or 10-mm tapped holes in the cylinder block oil pan rail) and installing a new timing gear cover and/or a new flywheel housing, use the two standard studs, No. 107AM5019M, and two flange-head nuts, No. 191AM2, to attach the oil pan to the flywheel housing and/or the timing gear cover. Lubricate and torque stud nuts to 15 lb-ft (20 N m) using torque wrench J 24406 or equivalent. A new timing gear cover with 8-mm holes for oil pan mounting was introduced with the 1994 certified E7-427 and E7-454 engines.

This timing cover is used in conjunction with the isolating oil pan arrangement, but is also the service replacement for timing covers with 10-mm tapped holes for oil pan mounting. The new style timing gear cover part No. is 333GB285AM. New flywheel housings with 8-mm tapped holes for oil pan mounting were also introduced on engines with the isolating oil pan gasket. As with the timing gear cover, the new housings are service replacements for flywheel housings with 10-mm tapped holes for oil pan mounting.

When servicing any engine with the isolating oil pan gasket (8-mm tapped holes in the cylinder block oil pan rail), and installing a new timing gear cover and/or flywheel housing, use the two shouldered studs, No. 616GC239M, with two flange-head nuts, No. 189AM1, with which the engine was originally built. Lubricate and torque shoulder bolts to 15 lb-ft (20 N m) using torque wrench J 24406 or equivalent. Two types of 8-mm studs will be supplied with all new timing gear covers and flywheel housing service assemblies. One type of stud is used if the engine has a fiber oil pan gasket, and the other type is used for engines with the isolating oil pan gasket.

[213 EV] CYLINDER HEADS Description When replacing a timing gear cover or a flywheel housing on an engine equipped with an isolating oil pan gasket, first remove the oil pan to prevent damaging the rubber isolating oil pan gasket. Each cylinder head is a one-piece casting covering three cylinders and securely held to the top of the cylinder block by special-head bolts. The inlet and exhaust valves, fuel injection nozzles and the engine compression brake housing assemblies (if equipped) are located in the cylinder heads. Valve seat inserts and valve guides are replaceable.

To prevent damaging the threads in the aluminum timing gear cover and the aluminum flywheel housing, be sure to use the designated studs rather than capscrews. When servicing an old engine with 10-mm tapped holes in the oil pan mounting rail with a new cylinder block with 8-mm holes, reinstall the old oil pan and a new fiber oil pan gasket with 26 new 8-mm fasteners, No. 421GC293M, at the cylinder block and four 10-mm fasteners, No. 66AM4, at the timing gear cover and flywheel housing. Lubricate and torque fasteners No. 421GC293 to 24 lb-ft (33 N m) using torque wrench J 24406 or equivalent.

Cast-iron sleeves pass through the coolant cavity of the cylinder head at the center of each cylinder. The fuel injection nozzle holder assemblies are installed in these sleeves. The sleeve design and installation provides effective cooling for the fuel injection nozzles, valves and cylinder head. This sleeve also provides a sealed passage for the nozzle return-to-tank fuel, which passes from the nozzle sleeve chamber into a drilled fuel return passage in the cylinder head and back to the fuel tank. The air inlet, coolant and exhaust manifolds are secured to the cylinder heads. The fuel inlet lines also enter the engine at the cylinder heads. Page 6-51 200 ENGINE ASSEMBLY