5-101.bk Page 52 Friday, March 17, 2006 11:05 AM Installation 2. Place a fire ring carefully in position on top of each cylinder sleeve. Ensure that the cylinder heads are in acceptable condition. Refer to the cylinder head inspection procedures in the BENCH PROCEDURES section in this manual. Check that the design of the fire ring used is the correct match for the cylinder sleeves installed. Refer to the TROUBLESHOOTING section for Proper Fire Ring/Cylinder Top Combinations. All MACK head gaskets are precoated and do not require any type of additional sealing compound. 3. Position the completely assembled cylinder heads on the cylinder block.
Locate the heads into the guide pins in the cylinder block. Refer to Figure 6-58. 1. Place the head gaskets in position on the locating pins in the cylinder block deck. Figure 6-58 — Cylinder Head Gasket and Fire Ring Positioning Page 6-52 200 ENGINE ASSEMBLY 1. Cylinder head 3 2. Gasket 4 . Fire ring . Cylinder block