Mack Trucks — 5-101.bk

5-101.bk Page 54 Friday, March 17, 2006 11:05 AM Refer to Figure 6-60. 7. Perform the engine run-in procedure, bringing temperatures up to the normal operating range. 6. Torque all head mounting capscrews in three stages to the specified torque. a. Torque all head mounting capscrews in sequence to 50 lb-ft (68 N m) using torque wrench J 24407 or equivalent. 8. After completing the run-in procedure, retorque the cylinder head capscrews in sequence, breaking each loose one at a time and then bringing it up to the specified torque. b. Torque all head mounting capscrews in sequence to 125 lb-ft (170 N m) using torque wrench J 24407 or equivalent. c.

Torque all head mounting capscrews in sequence to final torque value of 205 lb-ft (278 N m) using torque wrench J 24407 or equivalent. Figure 6-60 — Head Bolt Torque Sequence Chart Page 6-54 200 ENGINE ASSEMBLY