5-101.bk Page 55 Friday, March 17, 2006 11:05 AM [222 KG] NOZZLE HOLDER ASSEMBLY 2. Lubricate the nozzle holder surface and install O-ring on the nozzle holder. 3. Thread injection nozzle puller J 37093 into the top of nozzle holder. Refer to Figure 6-62. Description Each cylinder has a nozzle to ensure proper delivery of fuel that is metered and timed by the injection pump. The nozzle is positioned at the lower end of the nozzle holder. The nozzle holder is positioned vertically in the cylinder head and centered in the cylinder between the four valves.
The nozzle fuel inlet tube is inserted through the side of the cylinder head and the tapered end of the inlet tube seals the area between the tube and the nozzle holder. The tube is secured in position with a sleeve nut. Special Tool Required Injection Nozzle Puller J 37093 Installation 1. Insert a nozzle holder gasket in the bottom of the nozzle holder hole. Refer to Figure 6-61. Make sure the washer-type gasket is lying flat in the bottom of the nozzle holder bore. An alternate method of installing the washer-type gasket is to hold it in place on the bottom of the nozzle with a small dab of grease instead of placing the washer in the hole.
Figure 6-62 — Puller Application Figure 6-61 — Nozzle Holder Gasket Installation Page 6-55 200 ENGINE ASSEMBLY 1. Nozzle holder puller J 37093 2. Nozzle holder