Mack Trucks — 5-101.bk

5-101.bk Page 56 Friday, March 17, 2006 11:05 AM 4. Insert nozzle holder in the nozzle holder hole. Be sure to align the locator ball in the nozzle holder with the socket in the cylinder head to ensure inlet tube alignment. Refer to Figure 6-63. If the gauge block is too high, it may indicate that there are two gaskets installed under the nozzle holder, or the nozzle holder has not been fully inserted. If a gauge block is not available, measure the distance from the top of the cylinder head to the top of the nozzle holder. The nominal measurement should be 0.564 inch (14.326 mm). Figure 6-63 — Nozzle Holder Alignment 5.

After making sure that the nozzle holder ball is properly aligned with the alignment socket in the cylinder head, push downward on the handle of the installation tool driving the nozzle holder into position. Refer to Figure 6-64. Figure 6-65 — Nozzle Holder Installation Check 8. Lubricate the threads of the retaining plug and install in position. Torque to 45 lb-ft (61 N m) using torque wrench J 24407 or equivalent. Refer to Figure 6-66. Figure 6-64 — Nozzle Holder Installation 6. Remove the tool from the nozzle holder and insert the gauge block on the end of the tool handle. 7. Insert the gauge block into the nozzle holder hole.

The gauge block should be flush with the top of the cylinder head surface. Refer to Figure 6-65. Figure 6-66 — Retaining Plug Installation If the gauge block is below level, it may indicate that the gasket was omitted. Page 6-56 200 ENGINE ASSEMBLY 1. Nozzle holder puller 2 J 37093 . Gauge block