Mack Trucks — 5-101.bk

5-101.bk Page 57 Friday, March 17, 2006 11:05 AM [213 LH] VALVE LIFTER PUSH RODS The non-current push rod should be used only with the non-current lifter. If the non-current push rod with the wide flat or dimple is used in the current valve lifter which has no center hole, it may create an undesirable wear pattern in the lifter socket. Inspection Check the push rods. Replace any push rods that have loose ends, are bent, or show signs of excessive wear. Mixing current and non-current valve lifters is permissible when using the correct lifter/push rod combination. Identification Current push rod can be used with either valve lifter. Refer to Figure 6-67.

Do not use non-current valve lifter to service current valve lifter. The current E7 valve lifter has no hole in the center of the stem. In conjunction with this change, the E7 inlet and exhaust (nonbrake engine) push rods have a 0.060-inch (1.524 mm) maximum flat or dimple on the ball end. The push rod part number is etched or roll-stamped on the push rod. Only Dynatard exhaust push rods are not affected and can be used with current and non- current valve lifters. Dynatard intake push rods still need to be updated to current push rods when using current valve lifters.

CURRENT 369GC334 NON-CURRENT 369GC329A PUSH RODS SMOOTHLY ROUNDED OR 0.060" MAXIMUM FLAT OR DIMPLE 0.200" MAXIMUM FLAT OR DIMPLE WITHOUT CENTER HOLE WITH CENTER HOLE CURRENT 72GC357 NON-CURRENT 72GC347A 200579a Figure 6-67 — Valve Lifter/Push Rod Identification Page 6-57 200 ENGINE ASSEMBLY